Kohler K-1360-H2-0 Installation Guide download pdf (Page 13)

11. Complete the Finished Wall - Continued

Tiled Ledge Installation

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

Cover the framing with water-resistant wall material.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material. Seal the joints between the whirlpool rim and the ﬁnished wall material with silicone

sealant.

NOTE: The exposed area of the whirlpool rim must not be less than 37-5/8″ (95.6 cm) x 72″ (182.9 cm) in

order for the pillows to ﬁt properly.

Install the faucet trim according to the instructions packed with the trim.

Install the grip rails according to the installation instructions packed with the grip rails.

12. Complete the Concrete Installation

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

Apply mortar and tile to the wall, deck and surround material as needed.

Apply a bead of sealant where the tile meets the whirlpool surface.

Install the faucet trim according to the instructions packed with the trim.

13. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the

whirlpool, user keypad and remote control.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods

of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

Apply silicone

sealant to the

joint between the

finished wall and

the whirlpool rim.

Install the finished

ledge material.

First install water-resistant

wall material.

Install the finished

wall material.

Apply silicone sealant to the

joint between the finished

wall and the whirlpool rim.

Finished

Ledge

Whirlpool Flange

Framing

Kohler Co. 13 1022211-2-C

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Comments to this Manuals

No comments

Kohler K-1360-H2-0 Installation Guide Page 13

Comments to this Manuals

Related products and manuals for Above ground pool accessories Kohler K-1360-H2-0