Kohler K-1394-H2-96 Installation Guide download pdf (Page 11)

9. Complete the Finished Wall/Deck

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

Cover the framing with water-resistant wall material. Seal the joints between the whirlpool rim edge

and the water-resistant wall material with silicone sealant.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material so it is 1/16” (2 mm) above the enameled surface. Seal the joints between the whirlpool rim

and the ﬁnished wall material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

10. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the

whirlpool, user keypad and remote control.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods

of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

Apply silicone sealant to the water-resistant

wall material and the finished wall.

Install the finished

wall material.

First install

water-resistant

wall material.

Apply silicone sealant to the water-resistant

wall material and the finished wall.

Install the finished wall

material.

First install

water-resistant

wall material.

Drop-In Installation

Flush Installation

Whirlpool

Kohler Co. 11 1022205-2-D

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

No comments

Kohler K-1394-H2-96 Installation Guide Page 11