Kohler K-1394-H2-96 Installation Guide download pdf (Page 14)

13. Operating Sequence

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is

running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at

higher temperatures.

IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and

remote control.

NOTE: Your bath uses two pumps. One pump powers the Waterfall, and the second pump propels water

through the Flexjets and Riverjets.

To turn the whirlpool on: Press the Power On/Off button or rotate the outer ring to access a

desired mode, as described below.

To access a desired mode: Rotate the outer ring until the button is ﬂashing blue. Press “OK” to

activate the mode. The active mode will ﬂash green. To turn off a mode, rotate the outer ring until

the button is ﬂashing blue and press “OK” again. Verify each of the features listed below.

Waterfall: When activated, the Waterfall will start to ﬂow at medium volume within several

seconds. The Waterfall mode is not heated. Increase or decrease the water ﬂow by pressing either

the up or down arrow buttons on the keypad. An indicator bar in the center of the keypad shows

the water ﬂow volume. The Waterfall may be used alone, or with any one of the following; Flexjets,

Whitewater mode or Rapids mode.

Flexjets: When activated, the Flexjets, located lower in your whirlpool than the Riverjets, will start

to ﬂow at medium volume immediately. Increase or decrease the water ﬂow by pressing either the

up or down arrow buttons on the keypad. An indicator bar in the center of the keypad shows the

water ﬂow volume.

Whitewater: Whitewater mode activates the two outside Riverjets behind your neck to ﬂow at

medium volume. Increase or decrease the water ﬂow by pressing either the up or down arrow

buttons on the keypad. An indicator bar in the center of the keypad shows the water ﬂow volume.

Rapids: Rapids mode activates the four Riverjets behind your neck to ﬂow at medium volume.

Increase or decrease the water ﬂow by pressing either the up or down arrow buttons on the keypad.

An indicator bar in the center of the keypad shows the water ﬂow volume.

Tidepool: This feature turns off the air ﬂow to the jets for a soothing, relaxing effect. The Tidepool

feature may be used at any time while any of the jets are operating. The Tidepool mode does not

affect the Waterfall.

NOTE: Some air may ﬂow from one or more jets for a short time after the Tidepool feature has been

activated.

Flexjet Flow Mode

Activates Mode

Selected

Waterfall

Mode

Rotate outer

ring to access

desired mode

Power

On/Off

Chromatherapy-Specific

Color (H2 models only)

Heater

On/Off

Chromatherapy Cycle

(H2 models only)

Decreases

Flow

Tidepool

Indicator Bar - Shows

water flow volume

Riverjet Rapids Mode

Increases Flow

Riverjet

Whitewater Mode

Turn the Flexjet

trim clockwise to

decrease the flow.

Turn the Flexjet trim

counterclockwise to

increase the flow.

Lighted User Keypad

1022205-2-D 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Comments to this Manuals

No comments

Kohler K-1394-H2-96 Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Above ground pool accessories Kohler K-1394-H2-96