Kohler K-1394-H2-96 Installation Guide download pdf (Page 15)

Operating Sequence (cont.)

Heater: The built-in heater automatically helps to maintain the water temperature when any of the

jets are operating, as long as the water temperature does not exceed 104°F (40°C). The heater may be

turned off at any time while the pumps are operating, by rotating the outer ring until the heater

button is ﬂashing and pressing “OK”. Press “OK” again to turn the heater back on.

Your whirlpool jet system adds air to the water stream (when not in the Tidepool mode) to increase

the force of the water ﬂow. Decrease the force of the whirlpool water ﬂow by turning the whirlpool

trim rings clockwise until you obtain the desired water force. Turn the trim rings counterclockwise

to increase the water ﬂow force.

Press the Power On/Off button to turn the whirlpool off.

NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of

operation.

14. Chromatherapy Operation

Equipped on H2 Models Only

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when

the pumps are not operating.

Chromatherapy Cycle: When this mode is activated, the chromatherapy lights will automatically

and continuously cycle through the eight colors; white, violet, indigo blue, aqua blue, green, yellow,

orange and red. One cycle through all eight colors takes approximately one minute. Rotate the outer

ring to select this mode and press “OK” to activate it. Press “OK” while the chromatherapy mode is

active, to turn off the lights.

Chromatherapy Speciﬁc Color Selection: When this mode is activated, you may choose a speciﬁc

color for the bath. Rotate the outer ring to select this mode, press “OK” to activate and use the

up/down arrows to reach the desired color. Press “OK” while the chromatherapy mode is active, to

turn off the lights.

15. Remote Control Operation

NOTE: Refer to your Homeowners Guide for detailed instructions on your remote control.

The remote control places the whirlpool functions at your ﬁngertips. You may access and modify all

modes/features from the remote control. The waterproof remote control is designed to be used in

the bath and will ﬂoat in the water. The remote control uses two AAA batteries.

The mode selector button functions in the same way as the outer ring. When “M” is pressed, one of

the modes will ﬂash on the user keypad. If “M” is pressed again, the next mode in clockwise order

will ﬂash. When the desired mode is ﬂashing, press “OK” to activate it.

When the Flexjets, Waterfall, Whitewater or Rapids mode is active, the arrows will increase or

decrease the water ﬂow volume.

Troubleshooting

NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within

the USA and Canada, or 001-800-456-4537 from within Mexico.

NOTE: Outside North America, a GFCI may be known as a Residual Current Device (RCD).

Troubleshooting the Whirlpool System

Kohler Co. 15 1022205-2-D

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

No comments

Kohler K-1394-H2-96 Installation Guide Page 15