Kohler Thermostatic Electric Shower User Manual download pdf (Page 15)

Decide on a suitable position for the slide bar avoiding buried cables and

pipes.

Drill the two 7.0 mm xing holes for the slidebar at 600 mm centres and insert

the wall plugs.

Assemble the clamp bracket components. Push the plastic slidebar ends into

the slidebar.

Push the slidebar through the clamp bracket assembly, soapdish and hose

retaining ring.

Fit the bottom end support loosely to the wall. This will make aligning the top

support easier. Insert the xing screw into the countersunk hole of the plastic

slide bar end and through the slidebar support.

Place the screw through the top end support and fully tighten. Fully tighten

the bottom end support.

Fit the end support caps over the slidebar end supports.

Screw the hose onto the handset and the outlet of the shower (Make sure the

hose seals are tted). Do not overtighten.

Place the handset into the slidebar clamp bracket.

Note! The clamp bracket is tapered. The handset will only t properly from

one direction. If necessary turn the end of the clamp bracket until the handset

will t.

If the clamp bracket pivots downwards under the weight of the handset

the central securing screw in the bracket will require tightening to hold the

handset in position.

Installation of Shower Fittings

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Kohler Thermostatic Electric Shower User Manual Page 15