Kohler K-CB-CLC3526FS Installation Guide download pdf (Page 3)

1070224-2-B

Cabinet bottom sits

in lip on bottom

mounting bar.

#8 x 2" Hex

head screw &

Wall anchor

(use 1/4" driver)

11" bottom mounting bar for K-CB-CLC15/20,

K-3073

21" bottom mounting bar for K-CB-CLC25

INSTALLER’S NO

TE:

Installing the cabinet on a wall without the door attached can make installing easier

for one person. Do not mount the doors until the box is in or on the wall.

Wall anchor

(if required)

Top mount clip

#8 x 2" Hex head screw

(Use 1/4" driver)

INSTALLER’S NO

TE:

2. Surface mounting the cabinet on a wall.

A. Install Mounting Bar.

(Step one varies on type of cabinet

you have, see below.)

Fig. 3A – For Single Door

Fig. 3B – For

Two Door

2. Drill 3/16” hole in wall for mounting bar anchors at locations

shown in Fig. 3. (If you do not use the anchor, drill a 3/32”

pilot hole.) After the holes are drilled, fit the mounting bar

onto the wall, refer to Fig. 3 for measurements, and Fig. 5

for information on anchor cinching.

B. Install

Top Clips

(Left and right top clips come connected, hold

both clips and snap them apart).

1. Fit cabinet into position on mounting bar as

shown in Fig. 4A.

2. Place clip in position as shown in Fig. 4B and

mark with a pencil. Remove clip and cabinet and

drill the pilot or anchor holes where marked.

3. Fix both the clips into position with a screw, and

slide the clip into the up position. Sit the cabinet

on the mounting bar, then lower and tighten the

screws into place, as shown in Fig. 4C

4. See Fig. 5 on next page for proper turns required

for anchor cinching.

5. See page 4 for Side Kit Mirror application.

Fig. 4A

3/4"

4 1/2" from edge

Bottom of Cabinet

2" from edge

K-CB-CLC20

and K3073

K- CB-CLC15

1. Drill two 3/16 holes in bottom mounting bar at indent

location. Use the supplied anchors or locate studs

if possible.

Side of Cabinet

3/4"

Bottom of Cabinet

2" from edge

1. Drill three 3/16 holes in bottom mounting bar at indent

location. Use the supplied anchors or locate studs

if possible.

Side of Cabinet

If you are using a CLL Top Light

STOP HERE and follow the CLL instructions.

31" bottom mounting bar for K-CB-CLC35

26" bottom mounting bar for K-CB-CLC30

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Kohler K-CB-CLC3526FS Installation Guide Page 3

Comments to this Manuals

Related products and manuals for AV equipment stands Kohler K-CB-CLC3526FS