4. Speaker Connections
NOTE: This amplifier allows 2- or 4-speaker stereo output. Refer to
the connection diagram above for your wiring configuration.
NOTE: The speaker terminal will accept a 12-24 AWG wire. Follow
local codes for routing speaker wires.
Disconnect the power from the amplifier.
Using a wire stripper, remove approximately 1/2″ (13 mm) of
insulation from the speaker wire.
Insert the wire into the appropriate positive (+) or negative (-)
and right (R) or left (L) terminal connector.
Repeat for the remaining speaker wires.
Reconnect the power to the amplifier.
Verify that the status LED light turns on.
Series Connection - 4 Ohm Parallel Connection - 8 Ohm
Or
Speaker Terminal
+- +-+-+-
+- +-
RL
+
RL
+
-
+
-
-
+
-
-+-
RL
-++-+
+- +-
Kohler Co. 11 1232038-2-B
Comments to this Manuals