Kohler K-T10423-4S-CP Installation Guide download pdf (Page 3)

1. Install the Valve Stem Adapter

NOTE: Check the ﬁnished wall surface as related to the graphics on

the plaster guard.

Select the correct length valve stem adapter and valve stem

adapter screw for your application. Refer to the information

stamped on the plaster guard to verify the wall thickness.

For a thin wall - 3/16″ (5 mm) to 9/16″ (1.4 cm): use the 7/8″ (2.2

cm) (short size) valve stem adapter, stamped ″3″ on the plaster

guard, and the 3/4″ (1.9 cm) screw.

For a standard wall - 9/16″ (1.4 cm) to 1-1/16″ (2.70 cm): use the

1-3/8″ (3.5 cm) (middle size) valve stem adapter, stamped ″1″ on the

plaster guard, and the 1-3/8″ (3.5 cm) screw.

For a thick wall - 1-1/16″ (2.7 cm) to 1-9/16″ (4 cm): use the 1-7/8″

(4.8 cm) (long size) valve stem adapter, stamped ″2″ on the plaster

guard, and the 1-3/4″ (4.4 cm) screw.

Remove and discard the plaster guard from the volume control.

Place the spline adapter over the valve stem.

Set the correct valve stem adapter over the valve stem. Do not

completely press or screw the valve stem adapter into place

until instructed to do so.

Select the correct

valve stem adapter.

Remove and discard

the plaster guard.

Valve Stem

Adapter

Finished Wall

Spline

Adapter

Volume

Control

Kohler Co. 3 1041505-2-G

1 2 3 4 5 6 7 8 ... 23 24

No comments

Kohler K-T10423-4S-CP Installation Guide Page 3