Kohler K-T14491-4-BGD Installation Guide download pdf (Page 6)

3. Install the Trim

NOTE: If you are installing the K-T10424 trim, proceed to the

″Install the Trim - K-T10424″ section of this guide.

Firmly press the valve stem adapter onto the valve stem.

Secure the valve stem adapter to the valve with the correct length

screw, as selected in the ″Install the Valve Stem Adapter″ section

of this guide.

Align the holes on the front plate assembly and the valve.

NOTE: Be sure to select the correct length screw for your

application.

Attach the two screws through the front plate assembly and into

the valve. Do not overtighten.

Visually inspect the front plate assembly to ensure that the foam

seal is completely covering the wall opening. If not, stop the

installation and repair the wall opening.

Place the escutcheon against the wall. The drain hole in the

escutcheon should face downward in the 6 o’clock position.

Turn the handle assembly to the vertical 12 o’clock position.

Thread the handle assembly onto the hub of the front plate

assembly to secure the escutcheon in place.

NOTE: If the handle does not engage the valve or the escutcheon

does not tighten to the wall, replace the valve stem adapter with an

adapter of appropriate length.

Transfer Valve

Handle Assembly

Escutcheon

Screw

Valve Stem Adapter

Front Plate

Assembly

Screws

1041514-2-K 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Kohler K-T14491-4-BGD Installation Guide Page 6