Kohler K-T14491-4-BGD Installation Guide download pdf (Page 7)

4. Install the Trim – K-T10424

Firmly press the valve stem adapter onto the valve stem.

Secure the valve stem adapter to the valve stem with the correct

length screw, as selected in the ″Install the Valve Stem Adapter″

section of this guide.

Align the holes on the front plate assembly and the valve.

NOTE: Be sure to select the correct length screw for your

application.

Attach the two screws through the front plate assembly and into

the valve. Do not overtighten.

Visually inspect the front seal plate assembly to ensure that the

foam seal is completely covering the wall opening. If not, stop the

installation and repair the wall opening.

Place the escutcheon against the wall. The drain hole in the

escutcheon should face downward in the 6 o’clock position.

Thread the adapter ring onto the hub of the front plate assembly.

Place the handle assembly against the escutcheon by lining up the

pins in the handle assembly with the holes in the escutcheon.

Make sure the handle is in the 12 o’clock position and the

setscrew hole is facing down.

Tighten the setscrew in place with a hex wrench. Make sure the

handle assembly is tight against the escutcheon.

Valve Stem

Adapter

Screw

Transfer Valve

Escutcheon

Front Plate Assembly

Adapter

Ring

Handle

Assembly

Setscrew

Screws

Kohler Co. 7 1041514-2-K

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Kohler K-T14491-4-BGD Installation Guide Page 7