Kohler K-T16239-4-CP Installation Guide download pdf (Page 7)

4. Install the Trim - K-T10421

Firmly press the valve stem adapter onto the valve stem.

Secure the valve stem adapter to the valve stem with the correct

length screw, as selected in the ″Install the Valve Stem Adapter″

section of this guide.

Thread the two threaded studs into the threaded holes of the

valve.

Place the front plate assembly over the threaded studs.

Thread the nuts onto the studs to secure the front plate assembly

to the wall. Do not overtighten the nuts.

NOTE: If the front plate assembly does not lay ﬂat on the wall

surface, loosen the nuts and adjust the threaded studs, then

re-tighten the nuts. The maximum distance between the threaded

studs from the wall is 7/16″ (1.11 cm).

Inspect the front seal plate assembly to ensure that the foam seal

is completely covering the wall opening. If not, stop the

installation and repair the wall opening.

Place the escutcheon against the wall. The drain hole in the

escutcheon should face downward in the 6 o’clock position.

Thread the adapter ring onto the hub of the front plate assembly.

Adapter Ring

Setscrew

Escutcheon

Front Plate Assembly

Valve Stem

Adapter

Handle

Assembly

Thermostatic

Valve

Threaded Studs

Nuts

Screw

Finished

Wall

Kohler Co. 7 1041503-2-F

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Kohler K-T16239-4-CP Installation Guide Page 7