Kohler K-1167-GVL-K4 Installation Guide download pdf (Page 13)

9. Route the Cables (Without Chromatherapy and Heated Surface)

IMPORTANT! Several of the included bath components will be powered by the control ampliﬁer via 25’

(7.6 m) cables. Plan the location of the control ampliﬁer so the cables will reach without tension.

Connect the Cables at the Bubble Control

NOTE: The bubble control is mounted to the board at the end of the bath.

Connect the larger Ethernet end of the user interface cable to one of the two ports on the bubble

control.

Connect the inter-connect cable (both ends are Ethernet) for the ampliﬁer to the remaining port on

the bubble control.

Route the Cables Through the Framing

Carefully cut the cable tie securing the coiled transducer wires to the back of the bath.

Route the transducer wires through the framing to the control ampliﬁer location, drilling 1″ (52 mm)

holes where needed.

Route the inter-connect cable from the control board to the control ampliﬁer location. Include a drip

loop.

Route the user interface cable through the framing from the control board to the planned user

interface location. Include a drip loop.

NOTE: An auxiliary cable connection can be used to pair a BLUETOOTH

device or other

battery-operated audio device so users can play their own music with the vibracoustic bath.

If used, route an auxiliary-in cable (not included) to the control ampliﬁer location.

User Interface

Transducer Wires

Control Board

Inter-Connect

Cable

Optional Auxiliary-In

Cable

Bubble

Control

Inter-Connect

Cable

User Interface Cable

Bubble

Control

Drip Loop

Kohler Co. 13 1212245-2-B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

No comments

Kohler K-1167-GVL-K4 Installation Guide Page 13