Kohler K-1167-GVL-K4 Installation Guide download pdf (Page 17)

12. Install the User Interface

IMPORTANT! Do not allow the cable routed through the wall hole to fall into the wall.

Push a thin nail into the groove in the back side of the user interface to separate the interface from

the mounting plate.

Position the mounting plate over the cable and against the ﬁnished wall so the hooks are to the left.

Level the mounting plate and mark the screw hole locations on the wall.

Remove the mounting plate and drill 1/4″ holes at the marked locations.

Insert the provided wall anchors into the holes.

Apply a bead of silicone sealant to the two grooves on the back of the mounting plate.

Position the mounting plate over the cable with the hooks to the left, and secure to the wall using

the two screws provided.

Check for level. If needed, loosen the screws and adjust the mounting plate.

Connect the cable to the user interface.

Engage the edge of the user interface with the two mounting plate hooks, then ﬁrmly swing the

user interface against the mounting plate until they snap together.

Refer to the User Guide included with the interface to set up, program, and verify proper function

of the product.

Troubleshooting

NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within

the USA and Canada, or 001-800-456-4537 from within Mexico.

NOTE: The product model number is printed on a label on the blower side of the bath.

NOTE: For service parts information, visit your product page at www.kohler.com/serviceparts.

Anchors

Horizontal and

Vertical

Adjustment

Hooks

Screws

Pencil

Silicone

Sealant

Front ViewBack View

Mounting

Plate

User

Interface

Kohler Co. 17 1212245-2-B

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

No comments

Kohler K-1167-GVL-K4 Installation Guide Page 17