Kohler K-307-K-NA Installation Guide download pdf (Page 4)

3. Install the Mixer

Attach the mixer to the wall plate with the screws and washers

provided.

Tighten the screws securely.

Install 1/2″ hot and cold supply piping to the mixer valve.

Temporarily pull the plaster guards from the handle and spout

shanks. Do not discard them at this time.

Position a bucket in front of the spout shank, and turn on the

water supplies to the mixer valve.

Slowly open the mixer valve stems, and allow the hot and cold

water to ﬂow from the spout shank for about a minute.

Close the valve, and carefully inspect all connections for leakage.

Repair if necessary.

Turn off the water supplies. Open the valve stem to relieve the

water pressure.

Reattach the plaster guards to the handle and spout shanks.

Washers

Screws

Wall Plate

Mixer

1/2" Hot

Supply

1/2" Cold

Supply

Plaster

Guards

Setscrew

Handle

Assembly

1015917-2-D 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Kohler K-307-K-NA Installation Guide Page 4