Kohler K-307-K-NA Installation Guide download pdf (Page 5)

4. Finish the Wall

NOTE: To ensure proper ﬁt and appearance, do not oversize the

spout and handle shank holes.

Complete the ﬁnished wall with two 1-7/8″ (4.8 cm) diameter

holes for the spout and handle shanks. Space the hole centers 4″

(10.2 cm) apart.

Remove and discard the plaster guards when the ﬁnished wall is

complete.

5. Adjust the Water Temperature

NOTE: Prior to adjustment, make sure the handle is in the

maximum hot position.

Remove the handle, cap and escutcheon. Turn the water to the

maximum temperature by pushing the valve stem down and

turning counterclockwise.

Mark the current position of the temperature stop tab (top edge)

on the mounting nut with a marker or pencil. Lift both the

indexer and disc just enough to clear the splines and allow

rotation.

NOTE: Each spline notch represents an average 9.5° F (5.3° C)

temperature change.

Plaster

Guards

Mounting

Nut

Stop Tab

Valve Stem

Disc

Indexer

Splines

Kohler Co. 5 1015917-2-D

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Kohler K-307-K-NA Installation Guide Page 5