Kohler K-974-CP Installation Guide download pdf (Page 3)

1. Install the Posts

Locate Mounting Holes

IMPORTANT! The slide bar must be mounted to stud framing

supports at both the top and bottom mounting locations. Do not use

or depend on plastic wall anchors to attach the slide bar.

NOTE: The slide bar should not be installed in an area 24″ (61 cm)

to 48″ (121.9 cm) from the ﬂoor.

Mark the top mounting hole location then measure down 28″

(71.1 cm) from the ﬁrst mark to determine the bottom mounting

hole location. Verify both marked locations are over a stud.

For tile or solid surface material: Drill a 3/16″ hole through the

ﬁnished surface only. Do not drill into the stud or the screws may

not hold.

Install the Escutcheons and Posts

Apply silicone sealant into the groove on the backside of an

escutcheon.

Position an escutcheon and post over the top mounting hole.

Attach the escutcheon and post to the wall with the screw.

Loosely tighten the screw.

Hold the slide bar up against the posts. Adjust the position of the

posts until the slide bar ﬁts snug against the curved cutout of the

posts.

Remove the slide bar and tighten the screws to secure the posts.

Post

Screw

Mounting

Hole

28" (71.1 cm)

Mark the bottom mounting

minimum 48" (121.9 cm).

Escutcheon

Kohler Co. 3 1046145-2-A

1 2 3 4 5 6 7 8 ... 15 16

No comments

Kohler K-974-CP Installation Guide Page 3