Kohler Command Pro CH980 User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
Figure 1. Typical Command PRO Horizontal Shaft Engine.
Oil Recommendations
Using the proper type and weight of oil in the
crankcase is extremely important. So is checking oil
daily and changing oil regularly. It is also
recommended that a consistent brand of oil be used.
Failure to use the correct oil, or using dirty oil, causes
premature engine wear and failure.
Oil Type
Use high quality detergent oil of API (American
Petroleum Institute) service class SJ or higher. Select
the viscosity based on the air temperature at the time
of operation as shown in the following table.
Figure 2. Viscosity Grades Table.
NOTE: Using other than service class SJ or higher oil
or extending oil change intervals longer than
recommended can cause engine damage.
NOTE: Synthetic oils meeting the listed
classifications may be used with oil changes
performed at the recommended intervals.
However to allow piston rings to properly
seat, a new or rebuilt engine should be
operated for at least 50 hours using standard
petroleum based oil before switching to
synthetic oil.
A logo or symbol on oil containers identifies the API
service class and SAE viscosity grade. See Figure 3.
Figure 3. Oil Container Logo.
Refer to Maintenance Instructions beginning on page
8 for detailed oil check, oil change, and oil filter change
procedures.
Oil
Drain
Plugs
Oil Fill
Dipstick
Fuel
Pump
Electric
Starter
Oil Filter
Air
Cleaner
Throttle
Control
Lever
Choke
Control
Lever
Spark
Plug
Cylinder
Shrouds
Carburetor
Screen
Blower
Housing
5W-20, 5W-30
RECOMMENDED SAE VISCOSITY GRADES
10W-30
Kohler 10W-30
°F -20 0 20 32 40 60 80 100
°C -30 -20 -10 0 10 20 30 40
TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE
* Use of synthetic oil having 5W-20 or 5W-30 rating is acceptable,
up to 4°C (40°F)
** Synthetic oils will provide better starting in extreme cold below
23°C (-10°F)
**
*
SAE
10W-30
A
P
I
S
E
R
V
I
C
E
S
J
Lifting
Strap
Lifting Point
Page view 3
1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments