Kohler Command Pro CV980 User Manual download pdf (Page 80)

8.4

Section 8

Disassembly

Remove Fuel Pump

WARNING: Explosive Fuel!

ȱȱ¡¢ȱĚȱȱȱȱȱ¡ȱ

ȱǯȱȱȱ¢ȱȱȱǰȱȱ

ȱǰȱȱǰȱ¢ȱȱȱȱ

Ěǯȱȱȱęȱȱȱȱȱȱȱȱȱȱ

running, since spilled fuel could ignite if it comes in contact

with hot parts or sparks from ignition. Do not start the

engine near spilled fuel. Never use gasoline as a cleaning

agent.

NOTE: Based on the style of fuel pump used, refer to

the following.

Pulse Style Fuel Pump

The pulse style fuel pump is mounted to the side of

the control bracket. It may be removed separately or

with the bracket.

To remove separately:

ȱ ŗǯȱ ȱȱȱ¡ȱĚȱȱȱ

securing the fuel pump to the control bracket.

2. Disconnect the inlet, outlet, and pulse (vacuum)

ȱȱȱȱȱǯȱȱȱŞȬŗŘǯȱ

¢ȱȱ¢ȱȱǯȱ

Figure 8-12. Removing Pulse Pump.

Electric Fuel Pump

1. Removal will be determined based on mounted

location and application. Disconnect the lead

connections, fuel line connections and mounting

ȱȱǯȱ¢ȱȱ¢ȱ

remaining fuel.

Remove Control Bracket, Governor

Springs and Lever

1. Unhook the governed idle and governor springs

from the controls on the main bracket and the

governor lever. Note the color, location, and

ȱȱǯȱȱȱŞȬŗřǯ

ȱ Řǯȱ ȱȱĴȱȱȱȱ

spring from the governor lever at the small

ǯȱȱȱŞȬŗřǯ

Figure 8-13. Disconnect Linkages and Governor

Springs.

ȱ řǯȱ ¢ȱ¢ȱěȱȱȱǰȱȱȱȱ

washers (note assembly order), and disconnect

the choke linkage from the pivot lever. Do not

lose any parts. Secure the remaining pivot parts

with tape, to avoid losing them. Always use a

new pal nut during reassembly.

4. If the fuel pump is being removed with the

bracket disconnect the pulse (vacuum) hose and

ȱȱȱȱȱȱǯȱ¢ȱ

ȱ¢ȱȱǯȱȱȱŞȬŗŚǯ

Figure 8-14. Disconnecting Pulse Hose.

5. Remove the lower mounting screw going into

the intake manifold and remove the main control

ǯȱȱȱŞȬŗś

Governor

Springs

Throttle

Linkage

Pal Nut

Choke

Linkage

Pulse Hose

Mounting Screws

Outlet Hose

Fitting

Pulse

Hose

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 137 138

Comments to this Manuals

No comments

Kohler Command Pro CV980 User Manual Page 80

Comments to this Manuals

Related products and manuals for For the car Kohler Command Pro CV980