8.13
Section 8
Disassembly
8
Figure 8-52. Removing Oil Pan.
Oil Pump Assembly
The oil pump is mounted to the inside of the oil pan.
If service is required, refer to the service procedures
ȱȁȁȱȱ¢ȂȂȱȱȱşǯ
Remove Camshaft
ȱ ŗǯȱ ȱȱĞȱȱȱǻȱǼǯȱȱ
ȱŞȬśřǯ
Figure 8-53. Removing Camshaft.
Remove Connecting Rods with Pistons
and Rings
ŗǯȱ ȱȱȱ¡ȱĚȱȱȱȱ
closest connecting rod end cap. Remove the end
ǯȱȱȱŞȬśŚȱȱŞȬśśǯ
Figure 8-54. Removing Connecting Rod Screws.
NOTE: If a carbon ridge is present at the top
of either cylinder bore, use a ridge
reamer tool to remove the ridge before
Ĵȱȱȱȱǯ
Figure 8-55 Remove Connecting Rod Caps.
NOTE: The cylinders are numbered on the
crankcase. Use the numbers to mark
each end cap, connecting rod and piston
for reassembly. Do not mix end caps and
connecting rods.
Comments to this Manuals