Kohler Command Pro CV980 User Manual download pdf (Page 90)

8.14

Section 8

Disassembly

2. Carefully remove the connecting rod and piston

¢ȱȱȱ¢ȱǯȱȱȱŞȬśŜǯ

Figure 8-56. Removing Piston/Connecting Rod

Assemblies.

3. Repeat the above procedures for the other

connecting rod and piston assembly.

Remove Crankshaft

ŗǯȱ ¢ȱȱȱĞȱȱȱǯȱ

ȱȱŞȬśŝǯȱȱȱȱȱȱȱ

used.

Figure 8-57. Removing Crankshaft.

Removal of Governor Gear Assembly

ȱȱȱȱȱȱȱĞȱ¢ȱȱ

molded tabs in the gear. When the gear is removed

ȱȱĞǰȱȱȱȱ¢ȱȱȱȱ

must be replaced. Therefore, remove the gear only

ȱ¢ȱ¢ǯȱȱȱȱȱȱĞǰȱ

yoke, or gear condition does not require removal,

ȱȱȱ¢ȱȱĞȱȱǯȱȱȱȱ

necessary, perform as follows:

1. Remove the locking tab thrust washer and note

orientation.

2. Using a screwdriver, carefully pry up to unseat

governor gear assembly from the governor gear

Ğǯȱȱȱȱȱȱȱ

ȱ¢ǯȱȱȱŞȬśŞǯ

Figure 8-58. Removing Governor Gear.

ȱ řǯȱ ȱȱȱȱĞȱȱȱȱ

ǯȱȱȱĞȱ¢ȱȱȱȱ

needed.

Remove Governor Yoke, Cross Shaft, and

Oil Seal

1. Remove the two mounting screws securing the

¢ȱȱȱȱȱĞǯȱȱȱŞȬśşǯ

Figure 8-59. Removing Cross Shaft/Yoke Screws.

ȱ Řǯȱ ȱȱȱȱĞȱȱȱȱȱ

remove seal.

Governor Gear

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 137 138

No comments

Kohler Command Pro CV980 User Manual Page 90