Kohler Courage SV720 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
Change the oil and oil lter as follows.
1. The drain plug is located on the starter side of the
oil pan. See Figure 8. Clean the area around the
oil drain plug and the oil ll cap/dipstick.
2. Remove the drain plug and the oil ll cap/
dipstick.
3. Allow the oil to drain and then reinstall the drain
plug. Tighten 13.6 N·m (10 . lb.).
4. Remove the old lter and wipe o the lter
adapter with a clean cloth.
5. Place a new replacement lter in a shallow pan
with the open end up. Pour new oil, of the proper
type, in through the threaded center hole. Stop
pouring when the oil reaches the boom of the
threads. Allow a minute or two for the oil to be
absorbed by the lter material.
6. Apply a thin lm of clean oil to the rubber gasket
on the new oil lter.
7. Install the new oil lter to the lter adapter. Hand
tighten the lter until the rubber gasket contacts
the adapter, then tighten the lter an additional
3/4-1 turn.
8. Fill the engine with the proper oil to the FULL or
F” mark on the dipstick. Always check the oil
level with the dipstick before adding more oil.
9. Reinstall the oil ll cap/dipstick and tighten
securely.
10. Start the engine and check for oil leaks. Recheck
oil level before placing the engine into service.
Stop the engine, correct any leaks, and allow a
minute for the oil to drain down, then recheck the
level on the dipstick.
NOTE: To prevent extensive engine wear or damage,
always maintain the proper oil level in the
crankcase. Never operate the engine with
the oil level above the “F” or FULL mark, or
below the “L” or LOW mark on the dipstick.
Service Precleaner and Air Cleaner
Element
These engines are equipped with a replaceable, high
density paper air cleaner element. Some engines are
also equipped with an oiled, foam precleaner which
surrounds the paper element. See Figures 10 and
11. Two dierent capacity air cleaner systems are
available.
Check the air cleaner daily or before starting the
engine. Check for a buildup of dirt and debris around
the air cleaner system. Keep this area clean. Also check
for loose or damaged components. Replace all bent or
damaged air cleaner components.
NOTE: Operating the engine with loose or damaged
air cleaner components could allow unltered
air into the engine causing premature wear
and failure.
Figure 10. Courage Air Cleaner System.
Figure 12. Unhooking Latch (Courage).
Figure 11. Courage PRO Air Cleaner System.
Latch
Door
Element (Taller)
Precleaner (Some Models)
Precleaner (Some Models)
Latch
Air Cleaner
Element
Door
Door
Latch
Precleaner (Some Models)
Air Cleaner Element
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments