Kohler K-6812-PB Installation Guide download pdf (Page 7)

4. Install the Faceplate and Lever Handle

CAUTION: Risk of product damage to the K-306–KS valve

assembly. When using this valve in a ﬁberglass or acrylic

installation, use the Thin Wall Installation Kit (88526).

Remove and discard the plaster guard and/or dome, if installed.

Fit the faceplate and centering washer over the valve, and secure

with two screws.

Rotate the valve stem fully counterclockwise.

Lever Handle

Fit a sleeve and bonnet over each stem adapter.

Thread a bonnet to each valve body until they are tight against

the escutcheon.

Install a center cap to each bonnet.

Fit a long sleeve to each handle arm, and secure it with the end

cap.

Insert a handle arm through each center cap and bonnet.

Install a short sleeve and washer onto each handle arm and

secure them with the end cap.

Valve Stem

Faceplate

Screws

Centering Washer

Discard plaster

guard with dome.

Valve Stem

Short Sleeve

Handle Arm

Long Sleeve

O-Ring

Bonnet

Sleeve

Screw

Washer

End Cap

Center Cap

Kohler Co. 7 114498-2-E

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Kohler K-6812-PB Installation Guide Page 7