Kohler K-T16235-4-BN Installation Guide download pdf (Page 5)

2. Install the Showerhead

NOTICE: Do not use thread sealant compound (pipe dope) on the

shower arm threads. Instead, use thread sealant tape on the shower

arm threads. This will avoid clogging the showerhead spray outlets.

Remove the temporary nipple from the shower elbow.

Apply a bead of plumbers putty or other sealant to the back of

the wall ﬂange according to the manufacturer’s instructions.

Slide the wall ﬂange onto the shower arm.

Apply thread sealant tape to the threads shower arm and install

the shower arm to the shower elbow.

Carefully tighten shower arm to the shower elbow with a clean

strap wrench.

Press the ﬂange against the ﬁnished wall and secure to the

shower arm by tightening the setscrew.

Remove all excess putty.

With the showerhead off, run hot and cold water through the

shower arm to ﬂush out dirt and debris.

Apply thread sealant tape to the shower arm and thread the

showerhead to the shower arm.

Use a clean strap wrench to tighten the showerhead.

Check for proper operation.

Apply thread

sealant tape.

Setscrew

Flange

Shower Arm

Showerhead

Apply plumbers

putty.

Kohler Co. 5 1059598-2-C

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Kohler K-T16235-4-BN Installation Guide Page 5