Kohler K-T16235-4-BN Installation Guide download pdf (Page 8)

5. Install the Valve Trim

NOTICE: For K-306-KS valve: The thin wall installation kit (88526)

is required for ﬁberglass or acrylic installations.

NOTE: The handle assembly illustrated may not represent your

actual product. The installation instructions still apply.

For installation over a tiled wall, apply a bead of silicone sealant

around the back edges of the escutcheon.

Break off the tab at the lower right on the backing plate. Fit the

backing plate over the valve so the large hole is on the bottom

and secure with two screws. Do not overtighten.

Rotate the valve stem fully counterclockwise.

Position the escutcheon over the backing plate and thread the

collar into the backing plate. Do not cross thread.

Insert the sleeve into the notches of the collar and hand tighten. If

the collar does not thread into the backing plate, thread the

backing plate screws 1/2 turn back.

Turn the sleeve around so the cutout in the sleeve faces away

from the wall.

Place the handle assembly over the valve stem and tighten the set

screw.

Escutcheon

Collar

Sleeve

Setscrew

Handle

Assembly

Screws

Tab

Valve Stem

Backing

Plate

1059598-2-C 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Kohler K-T16235-4-BN Installation Guide Page 8