Kohler K-1913-LW-47 Installation Guide download pdf (Page 18)

9. Position the Bath

All Installations

IMPORTANT! If the installation site is in an area where frequent or prolonged power outages occur,

Kohler Co. recommends that a minimum 350 VA Uninterruptible Power Supply (UPS) be installed as a

backup power source for the bath controller.

IMPORTANT! If a handshower is being installed, follow the instructions packed with the handshower.

Make sure the handshower installation conforms to all applicable backﬂow prevention requirements.

Install any valving or accessories.

Adjust each of the six leveling feet until they extend 1/4″ (6 mm) to 1/2″ (13 mm) from the base of

the frame.

Install the grab bar and slotted overﬂow drain following their installation instructions. If the PVC

pipe included with the drain is too short, cut a new length using commonly available 1-1/2″

Schedule 40 PVC pipe.

If a UPS backup power supply is being installed to the controller, install it now following the UPS

manufacturer’s instructions. Do not connect the power source to the UPS at this time.

Reassemble the Bath (if disassembled)

NOTE: The following steps are not required if you did not disassemble the bath. If the bath has not been

disassembled, proceed to ″Move the Bath Into the Stud Pocket″ steps below.

Cover the area of the bathroom ﬂoor where the bath will be reassembled with protective material.

Move the bath and support frame from the staging area to the installation area.

If the bath was removed from the frame, carefully position and center the bath on the frame.

Attach the bath to the support frame.

Bracket

Wood Block (4)

Bottom View

Leveling Foot Locations (6)

Install the bath to the frame.

Align all of the holes.

Controller

1128532-2-G 18 Kohler Co.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 155 156

No comments

Kohler K-1913-LW-47 Installation Guide Page 18