Kohler K-1913-LW-47 Installation Guide download pdf (Page 23)

Install the Receptor Tray, and Connect the Drains (cont.)

Dry ﬁt the pulley assemblies and mounting brackets by aligning the holes.

IMPORTANT! Conﬁrm the receptor tray and pulley assemblies do not contact each other. If the receptor

tray and pulley assembly come in contact with each other, remove the receptor tray, remove any

obstructions with the subﬂoor, and reposition the receptor tray as needed.

IMPORTANT! Cover the receptor tray with protective material to avoid damaging it.

All Installations

Connect each of the three drains to their corresponding drain outlet. Each requires a 1-1/2″ drain

line. The drain valve connection requires a 1-1/2″ NPS coupling (not provided).

Route the accumulator drain line loosely through the cable tie attached to the receptor tray. Locate

the outlet of the drain line directly over the drain, with a minimum 2-1/2″ (64 mm) air gap

(typically required by code) to protect against back siphoning.

IMPORTANT! Cover the receptor tray with protective material to avoid damaging it.

Kohler Co. 23 1128532-2-G

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 155 156

No comments

Kohler K-1913-LW-47 Installation Guide Page 23