Kohler K-1913-LW-47 Installation Guide download pdf (Page 36)

20. Install the Trim Caps and Access Panel

All Installations

Secure the wall trim caps to the studs.

Align the wall trim cap nailing-in ﬂange with the bath nailing-in ﬂange.

Secure the wall trim cap to the studs using nails or screws.

Install the trim cap covers over the wall trim caps using the magnets and check for smooth

operation.

Attach the access panel using the attached fasteners. If the door contacts the access panel while

being raised and lowered, go to ″Optional Brush Seal Adjustments and Access Panel Bracket″ below.

Check Door Operation

Recheck the door movement, using one ﬁnger to move the door up and down.

When properly adjusted the door should move up and down using one ﬁnger.

Adjust as needed (″Optional Brush Seal Adjustments and Access Panel Brackets″).

Repeat until the door operates smoothly.

Optional Brush Seal Adjustments and Access Panel Brackets

NOTE: The brush seal, located on the bottom of the door, is designed to disperse water released when the

seal deﬂates, eliminating splashing beyond the receptor tray.

If the seal is adjusted incorrectly water may splash beyond the receptor tray or it may interfere with the

access panel.

Install the access panel.

Install the trim caps.

Wall Trim Cap

Trim Cap Cover

Access Panel

Mounting Bracket

Brush Seal

1128532-2-G 36 Kohler Co.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 155 156

No comments

Kohler K-1913-LW-47 Installation Guide Page 36