Kohler 13ERG User Manual download pdf (Page 38)

28 Reconnection/Adjustments TP-6335 9/04

8.2 Advanced Digital Control

(ADC 2100)

The model 10/13/15ERG generator sets use the

ADC 2100. The ADC 2100 uses password-protected

menus for generator output adjustments and controller

configuration.

This section contains instructions for using the ADC’s

password-protected menus to check and adjust the

generator output and controller configuration. The

controller configuration and generator set output are

factory-set and should not require field adjustment

under normal circumstances. Check and adjust the

configuration and/or output in the following cases:

D Check and adjust the controller configuration and

generator output after generator set reconnection to a

different voltage.

D Check the controller configuration when

troubleshooting generator set problems.

D Check and adjust the generator set output after

installation if the voltage requires adjustment for a

particular application.

8.2.1 Configuration Mode Time Out

The controller will automatically exit the configuration

mode without saving any changes after about 1 minute if

no buttons are pressed. Start the configuration

procedure over again from the beginning if the controller

exits the configuration mode before the settings have

been saved.

8.2.2 Controller Software Version

Number

The application software for controller operation is

factory-loaded onto the Advanced Digital Control. At

times, it may be necessary to check the software version

number for troubleshooting purposes.

The controller’s application s oftware version number is

displayed on the LED screen during the key sequence to

enter the configuration mode, after the Select button has

been pressed and held for about five seconds. For

example, 01.00 will be displayed for software

version 1.00.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

No comments

Kohler 13ERG User Manual Page 38