Kohler Power Systems 14/20RESA User Manual download pdf (Page 25)

TP-6804 12/11 25Section 2 Generator Set Operation

2.5.4 Resetting the Controller after a

Fault Shutdown

Always identify and correct the cause of a fault

shutdown before resetting the controller. Check the

fault message displayed on the controller and refer to

Figure 2-3 to identify and correct the fault condition

before proceeding. Contact an authorized

distributor/dealer for service, if necessary.

RDC2 Controller

Press the OFF button to reset the controller, or follow the

procedure below. See Figure 2-2.

1. While the fault message is displayed, press the

Select button to go to the Overview menu.

2. Press Select again. The active fault message is

displayed.

3. Press Select. Confirm Clear Fault: NO is

displayed.

4. Press the Down arrow button. Confirm Clear Fault:

YES is displayed.

5. Press the Select button to enter YES and clear the

fault.

6. Press the Select button to return to the overview

menu. The controller changes to OFF mode.

7. Press AUTO to put the generator set into automatic

mode.

DC2 Controller

Press the OFF button to clear the fault message on the

controller.

Overview ---->

1.2 h

Fault Message

tp6809

Confirm Clear

Fault: NO

Confirm Clear

Fault: YES

Fault Message

Press Up arrow button.

Figure 2-2 Clearing a Fault on the RDC2 Controller

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

No comments

Kohler Power Systems 14/20RESA User Manual Page 25