Kohler Bath Whirlpool K-1110-CT User Manual download pdf (Page 5)

Operation

NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide

before calling a qualiﬁed service representative.

Whirlpool

NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will

automatically maintain the water temperature when the whirlpool is running, as long as the water

temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.

Close the drain, then ﬁll the whirlpool to a level at least 2″ (5.1 cm) above the highest effervescent

port. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.

Press the power icon to turn on the whirlpool pump and heater. Water will ﬂow at medium volume.

Press the up or down arrow icons to increase or decrease the water ﬂow. The indicator bar will

display the water ﬂow volume.

If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the

heater back on.

Press the power icon a second time to turn off the whirlpool pump and heater.

NOTE: The pump and heater will automatically stop after approximately 20 minutes of continuous

operation. If desired, press the power icon to reactivate the pump and heater.

Carefully exit the bath, then open the drain to empty the whirlpool.

Effervescence

Rotate the outer ring until the effervescence icon is ﬂashing, then press OK to activate the

effervescence ports. The water ﬂow volume will remain as previously set. Press OK while the

effervescence mode is ﬂashing to turn off the effervescence ports.

Chromatherapy

NOTE: The chromatherapy modes may be used with all modes of operation, even when the pump is not

operating.

Rotate the outer ring to select the chromatherapy mode, then press OK to activate the

chromatherapy lights. Press OK while the chromatherapy mode is active to turn off the

chromatherapy lights.

Rotate the outer ring to select chromatherapy speciﬁc color selection, then press OK. Use the up or

down arrow to reach the desired color. Press OK while the chromatherapy speciﬁc color selection is

active to turn off the chromatherapy lights.

Kohler Co. 5 1023261-5-C

1 2 3 4 5 6 7 8 9 10 ... 51 52

No comments

Kohler Bath Whirlpool K-1110-CT User Manual Page 5