Kohler Bath Whirlpool K-1418-CT User Manual download pdf (Page 5)

Lighted User Keypad

Available modes will be illuminated in blue. Active modes will be illuminated in green.

Power Turns the whirlpool pump on and off. Icons illuminated in blue indicate available

modes/features. Modes which are operating will be illuminated in green.

Outer Ring Rotate the outer ring to the desired mode. The selected mode will ﬂash blue.

OK Activates the desired mode.

Up Arrow Increases the water ﬂow when the Flexjet ﬂow mode is active.

Indicator Bar Displays the water ﬂow volume in the Flexjet ﬂow mode.

Effervescence

Mode

Ports activate to provide a gentle, soothing bubbling action.

Down Arrow Decreases the water ﬂow when the Flexjet ﬂow mode is active.

Chromatherapy

Cycle

Chromatherapy lights will automatically and continuously cycle through the eight colors:

white, violet, indigo blue, aqua blue, green, yellow, orange, and red. One cycle through all

eight colors takes approximately one minute.

Heater Automatically engages when the power icon is selected. Rotate the outer ring until the

heater mode is ﬂashing, then press OK to turn the heater off. Press OK again to turn the

heater back on.

Chromatherapy -

Speciﬁc Color

Press OK to activate, then use the up or down arrow to reach the desired color. Press OK

while the chromatherapy cycle is active to turn off the chromatherapy lights.

Operation

NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide

before calling a qualiﬁed service representative.

Whirlpool

NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will

automatically maintain the water temperature when the whirlpool is running, as long as the water

temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.

Close the drain, then ﬁll the whirlpool to a level at least 2″ (5.1 cm) above the highest effervescent

port. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.

Press the power icon to turn on the whirlpool pump and heater. Water will ﬂow at medium volume.

Press the up or down arrow icons to increase or decrease the water ﬂow. The indicator bar will

display the water ﬂow volume.

If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the

heater back on.

Chromatherapy Cycle

Heater On/Off

Decreases Flow or Pulse

Effervescence Mode

Increases Flow or Pulse

Rotate outer ring to

access desired mode.

Power On/Off

Chromatherapy - Specific Color

Activates Mode Selected

Indicator Bar

Kohler Co. 5 1023246-5-C

1 2 3 4 5 6 7 8 9 10 ... 51 52

Comments to this Manuals

No comments

Kohler Bath Whirlpool K-1418-CT User Manual Page 5

Comments to this Manuals

Related products and manuals for Kitchen Kohler Bath Whirlpool K-1418-CT