Kohler K-3901-0 Installation Guide download pdf (Page 14)

5. Install the Toilet

Position the Toilet

Carefully lower the toilet into place, making sure the water supply line and electrical cord do not

interfere with the toilet when it is in place.

Connect the water supply hose to the supply stop.

Connect the docking station power cord (if included).

Connect the optional external FM antenna (not shown) to the toilet if needed.

Connect the external speaker wires (not shown) to the toilet if external speakers are installed.

IMPORTANT! The remote control will not function when removed from the docking station until it has

charged for approximately 30 minutes. Flush the toilet manually or use the remote control while it is

attached to the docking station using the buttons on the toilet until the remote control is fully charged.

Place the remote control on the docking station.

Turn on the water supply.

Connect the power.

Check for Leaks

NOTE: Once the power is connected, the toilet will automatically enter start-up mode. This process takes

several minutes.

NOTE: If there is a failure during start-up mode, follow the directions on the remote control.

Once the start-up sequence has been completed ﬂush the toilet using the manual buttons on the side

of the toilet.

Cap

Screw

Bushing

Wall Supply

Installation

Shown

Docking

Station

Cord

Docking

Station Cord

(if included)

FM Antenna

Connection

External

Speaker

Connections

1212876-2-B 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

No comments

Kohler K-3901-0 Installation Guide Page 14