Kohler K-3901-0 Installation Guide download pdf (Page 7)

Roughing-In - Through-the-Floor Water and Electrical

NOTICE: The locations for the supply shut-off, electrical outlet, and docking station cord are suggested

locations. Make sure all installations adhere to applicable codes and standards.

IMPORTANT! Do not install any items behind the toilet that will interfere with the seat when it is raised.

All decorative items should be at least 37″ (940 mm) high to allow clearance for the seat.

IMPORTANT! Consult the remote control documentation for the recommended remote control location.

The supplied power cord is 56″ (1422 mm) in length.

The toilet is equipped with a motion sensor to automatically open the cover when movement is

sensed. This sensor has a maximum range of 51-1/2″ (1300 mm). Sensitivity can be adjusted using

the User Interface.

The toilet is equipped with a seat actuator sensor, located on the right side of the toilet. This sensor

has a maximum range of 8″ (203 mm). Keep this area free of obstructions.

1/2″ OD compression supply stop outlet is required unless an adapter is used.

Installation of a water hammer arrestor is required.

Front of Bowl

25-3/4" (654 mm)

Finished Wall

Ø 1-1/2" (38 mm)

Water Supply Hole

Ø 1-1/4" (32 mm)

Power Supply Hole

Ø 2-5/8"

(67 mm)

14-1/2"

(368 mm)

25-1/4"

(641 mm)

10-13/16" (275 mm)

3-3/4" (95 mm),

3-9/16" (90 mm) Min

29-1/2" (749 mm)

12"

(305 mm)

12"

(305 mm)

15-5/8"

(397 mm)

2-1/4"

(57 mm)

1-3/4"

(44 mm),

1-1/2"

(38 mm)

Min

36-1/4"

(921 mm)

4-3/4" (121 mm)

17-7/8"

(454 mm)

L Of Outlet

13-5/8"

(346 mm)

Kohler Co. 7 1212876-2-B

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Comments to this Manuals

No comments

Kohler K-3901-0 Installation Guide Page 7

Comments to this Manuals