Kohler Courage SH265 User Manual download pdf (Page 12)

4. Slide the precleaner (D) and paper element (F)

onto the air cleaner stud (G). Secure with special

washer (E) and wing nut (C) (some models).

5. Reinstall the air cleaner cover (B) and secure with

wing nut (A).

Ignition

This engine is equipped with a dependable

maintenance-free ignition system. Other than

periodically checking/replacing the spark plug,

no adjustments are necessary or possible with this

system.

In the event starting problems should occur that are

not corrected by replacing the spark plug, see your

Kohler Engine Service Center.

NOTE: Some engines may be equipped with

components that comply with RFI

regulations.

Spark Plug

See Figures

and

Yearly or every 100 hours of operation, remove the

spark plug, check its condition, and reset the gap or

replace with a new plug as necessary. The original

spark plug is a Champion® RC12YC; the Kohler

equivalent is Kohler Part No. 12 132 02-S or for RFI

Kohler Part No. 25 132 14-S. Equivalent alternate

brand plugs can also be used.

1. Before removing the spark plug (D), clean the

area around the base of the plug to keep dirt and

debris out of the engine. See Figure 1.

2. Remove the plug (D) and check its condition.

Replace the plug if worn or if reuse is

questionable. See Figure 16.

3. Check the gap (B) using a feeler gauge (A). See

Figure 16.

NOTE: Do not clean the spark plug in a machine

using abrasive grit. Some grit could remain in

the spark plug and enter the engine, causing

extensive wear and damage.

4. Adjust the gap (B) by carefully bending the

ground electrode (C). Gap spark plug to 0.76 mm

(0.030 in.). See Figure 16.

5. Reinstall the spark plug into the cylinder head.

Torque the plug to 20 N·m (14 . lb.).

Fuel Filter (If Equipped)

WARNING

Explosive Fuel can cause res

and severe burns.

Do not ll the fuel tank while the

engine is hot or running.

Replace with a Kohler fuel lter yearly or every

50 hours of operation. Removing the air lter cover

will allow easy access to the fuel lter for servicing.

Fuel Tank Screen

See Figure

A serviceable fuel tank screen is located under the fuel

tank cap, in the ller neck.

WARNING

Explosive Fuel can cause res

and severe burns.

Do not ll the fuel tank while the

engine is hot or running.

Daily, or as required, clean screen of any accumulation

as follows:

1. Remove the fuel tank cap (A) and screen (B).

2. Clean the screen (B) with solvent. Replace if

damaged.

3. Wipe the screen (B) and insert it into the ller

neck (C).

4. Tighten the tank cap (A) securely.

Fuel Valve

See Figure

Engines are equipped with a fuel valve and integral

screen lter located at the inlet of the carburetor. It

controls and lters fuel ow from the tank to the

carburetor.

Every 100 hours of operation clean fuel valve cup

of any accumulated debris. If the screen becomes

clogged or damaged, replace it.

WARNING

Explosive Fuel can cause res

and severe burns.

Do not ll the fuel tank while the

engine is hot or running.

1. Stop the engine.

2. Turn the fuel valve lever (A) to the OFF position.

3. Remove the fuel valve cup (C).

4. Clean the fuel valve cup (C) with solvent and

wipe it o.

5. Check the O-ring (B). Replace if damaged.

6. Place the O-ring (B) on the fuel valve cup (C).

Rotate the fuel valve cup until it is nger tight.

Turn with a wrench 1/2 to 3/4 full turn.

7. Turn the fuel valve (A) to the ON position and

check for leaks. If fuel valve cup leaks repeat

steps 5 and 6.

8. Tighten the tank cap securely.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Kohler Courage SH265 User Manual Page 12

Comments to this Manuals

Related products and manuals for Motor vehicle accessories & components Kohler Courage SH265