Kohler K-1713 Installation Guide download pdf (Page 4)

1. Determine the Layout

WARNING: Risk of property damage. Allow a minimum of 12″ (30.5 cm) of air space around the

steam generator at all times. This provides an area for the heat generated by the unit to dissipate.

WARNING: Risk of personal injury. Do not install the Steam Control User Interface outside the

steam enclosure. The User Interface must be installed within the enclosure to allow the sensors to

regulate the temperature and control the ﬂow of steam. Refer to the Installation Guide for the

Steam Control Kit.

NOTICE: When installing the control kit, allow room in the control cable for a drip loop. The drip loop

will discourage moisture from following the control cable to the steam generator.

NOTICE: The steam generator will perform best when installed as close as possible to the steam head. The

unit should be installed within 25’ (7.62 m) of the steam head.

NOTICE: For optimum performance install the steam generator below the level of the steam head.

NOTE: When possible, use 45 degree elbows. Performance will be increased when 45 degree elbows are

used.

Determine the location of the steam generator. Allow for a 12″ (30.5 cm) air gap on all sides of the

generator. Allow for a drain pan.

Choose a drain pan appropriate for your installation. The drain pan is not supplied.

Tee

Steam Head

Control Cable Input

Pressure Relief Valve

Copper

Union

Shut-Off

Valve

Water

Inlet

Recommended

In-Line Water Filter

Front of Generator

(Access Panel)

Pitch toward generator.

Drain Pan

Install copper union as close

as possible to steam generator.

1053772-2-E 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Kohler K-1713 Installation Guide Page 4