Kohler K-1713 Installation Guide download pdf (Page 5)

2. Determine the Location of the Steam Hardware

WARNING: Risk of personal injury. Do not install the Steam Control User Interface outside the

steam enclosure. The User Interface must be installed within the enclosure to allow the sensors to

regulate the temperature and control the ﬂow of steam. Refer to the Installation Guide for the

Steam Control Kit.

WARNING: Risk of scalding. Do not block the steam head or locate it near a seat or bench, as the

steam head is hot during operation and may scald the user if touched.

Steam Head and Control Applications

NOTE: All dimensions should be taken from the inside of the shower.

IMPORTANT! Do not install the Steam Control User Interface outside the steam enclosure. Review the

Installation Guide for the Steam Control Kit. Do not install the control directly above or in-line with the

steam head.

Refer to the Steam Control Kit Installation Instructions for more information.

It is recommended to locate the steam heads and the steam control on the same wall as the

plumbing controls.

Locate the steam heads 6″ (15.2 cm) above the shower ﬂoor and 4 1/2″ (11.4 cm) from the threshold.

Locate the steam control 60″ (152.4 cm) above the ﬂoor of the shower, but not directly in-line with

the steam heads. Refer to the Steam Control Kit Installation Instructions for more dimensional and

installation information.

Make sure there is adequate clearance between the steam lines and any surrounding surfaces.

Wall Stud

6" (15.2 cm) from Floor

Provide clearance

from wall.

2-1/2" (6.4 cm)

Kohler Co. 5 1053772-2-E

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Kohler K-1713 Installation Guide Page 5