Kohler K-638-K-NA Installation Guide download pdf (Page 10)

5. Connect the Components

CAUTION: Risk of electric shock or product damage. Make sure the power cord is unplugged

before removing the access covers.

Low Voltage Connections – Controls and Components

Note: For wireless applications an Ethernet connection is not needed.

Remove the low voltage access cover.

Remove the grommets in the locations where the cables will be installed. Refer to the ″Connection

Key.″

Gently press each connection until it snaps together.

Slide the cable grommet into the slot with the male end up. Verify the grommet is properly seated.

High Voltage Connections – Lights and Power

IMPORTANT! Use only copper wire for high voltage connections.

Remove the high voltage access cover.

If connecting a light, remove the knockout.

TIP: To remove the knockout, use a ﬂat-blade screwdriver and gently tap with a hammer. Use care not to

damage the internal components.

Secure the cable to the media box using the watertight strain relief ﬁtting provided.

Connect the wire for line, neutral, and ground according to the above illustration. Secure each wire

to the appropriate terminal.

Make sure power cord

is unplugged before

opening access covers.

1/2" (1.3 cm) D.

Knockout

Grommet

Male End

Slide grommet into slot

with male end up.

High Voltage

Access Cover

Low Voltage

Access Cover

Install grommets

flush with media box.

Indicator Light

Line

Neutral

Ground

Use copper

wire only.

Lighting Connection

1069763-2-D 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Kohler K-638-K-NA Installation Guide Page 10