Kohler K-638-K-NA Installation Guide Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
2. Prepare the Site
CAUTION: Risk of product damage. The media box is rated to operate in temperatures up to
104°F (40°C). Do not install under a whirlpool surround or in any location where the temperature
may exceed 104°F (40°C).
The media module is designed to fit within a 13” (33 cm) to 19” (48.3 cm) wide 2x4 stud cavity. The
cavity should be free of cross bracing and insulation.
Locate the upper bracket a minimum of 24” (61 cm) down from the top of the stud cavity and a
minimum of 32-1/2” (82.6 cm) above the bottom of the stud cavity.
Measure 2-5/8 (6.7 cm) to 2-7/8 (7.3 cm) in from the stud face to determine the bracket placement.
Mark the bracket locations with a pencil.
Install a 120 V GFCI electrical outlet within the stud framing, in close proximity to the media
module.
If used, run the Ethernet cable to the media module installation site.
Using a hole saw, drill 1” (2.5 cm) holes through the studs at the top and bottom of the wall cavity
to allow for proper air flow.
Drill 1" (2.5 cm) holes at
top and bottom of wall
cavity for ventilation.
Outlet
Drip Loop
20-1/2"
(52.1 cm)
24" (61 cm)
Min
12" (20.5 cm)
Min
13" (33 cm) to
19" (48.3 cm)
Pencil
Pencil
Media Box
(not installed)
2-5/8" (6.7 cm) to
2-7/8" (7.3 cm)
1069763-2-D 6 Kohler Co.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Comments to this Manuals

No comments