Kohler K-1166-C1-96 Installation Guide download pdf (Page 15)

12. Complete the Finished Wall or Deck

NOTICE: Provide unrestricted service access to the pump, in-line heater, adjustable feet, and control box.

You must construct an access panel to provide sufficient clearance for servicing the pump, in-line heater,

and control box.

Protect the product surface. Cover the framing with water-resistant wall material.

Keep the entire overﬂow channel area exposed to allow access to the drain overﬂow, and to permit

easy cleaning of the overﬂow channel surfaces.

Seal the joints between the rim edge and the water-resistant wall or deck material with silicone

sealant.

Tape and mud the water-resistant wall material.

Install the ﬁnished wall to the water-resistant wall material.

Seal the joints between the product rim and the ﬁnished wall material with silicone sealant.

13. Install the Faucet Trim

Install the faucet trim according to the instructions packed with the trim.

14. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

bath surface. Use warm water and a liquid detergent to clean the surface.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any bath surfaces for long periods of

time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

Deck

Silicone Sealant

Finished Deck

2x4 Studding

Water-Resistant

Wall Material

Kohler Co. 15 1054216-2-B

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

No comments

Kohler K-1166-C1-96 Installation Guide Page 15