Kohler K-1166-C1-96 Installation Guide download pdf (Page 17)

16. Chromatherapy Light Operation

NOTE: These directions pertain to the use of the mounted control switch only. For more information, see

the ″Using the Remote Control″ section.

If the chromatherapy lights are turned off, press the button on the chromatherapy control switch

(located next to the pump control switch). The chromatherapy lights will begin to cycle through

each of the colors (sweep mode).

When the chromatherapy lights are in sweep mode, you can lock in one color light by pressing the

chromatherapy control switch.

When an individual color is locked in, press the chromatherapy control switch to turn the

chromatherapy lights off.

17. Troubleshooting Procedures

For warranty service, contact your dealer or wholesale distributor. This Troubleshooting Guide is for general

aid only. Contact a Kohler Authorized Service Representative or a qualiﬁed electrician to correct all electrical

problems. For warranty service, contact your dealer or wholesale distributor.

Symptoms Probable Causes Recommended Action

1. Green light in ″On/Off″

control switch ﬂashes

before the bathing well is

full of water.

A. Spout ﬁlls directly into overﬂow

channel.

A. Adjust/reinstall the spout to ﬁll

directly into the bathing well.

Refer to the installer/dealer.

B. One or both butterﬂy valves do

not work.

B. Check the butterﬂy valve wiring

or replace the butterﬂy valves.

Refer to the installer/dealer.

C. Control does not work. C. Check the wiring or replace the

control. Refer to the

installer/dealer.

2. Product does not start. A. No power to unit. A. Turn on the power to the unit, or

correct the source of the power

loss. Refer to the installer/dealer.

B. Water does not cover the overﬂow

channel sensors.

B. Fill the bathing well until water

ﬂows over the bathing well rim,

into the overﬂow channel, and

covers the overﬂow channel

sensors. Suggested ﬁll level is to

the drain overﬂow.

C. ″On/Off″ control switch does not

light up or ﬂash when the unit is

running or ﬁlled as required.

C. Check the wiring or replace the

″On/Off″ control switch. Refer to

the installer/dealer.

D. Pump/motor does not work. D. Rebuild or replace the

pump/motor. Refer to the

installer/dealer.

E. Control does not work. E. Check the wiring or replace the

control. Refer to the

installer/dealer.

3. Water does not cascade

evenly over the entire

bathing well rim.

A. Unit is not level. A. Level the unit by using the

wrench provided to turn the

adjustable feet up or down as

needed.

B. Bathing well ports are blocked. B. Remove blockage.

C. Metal suction screen is blocked. C. Clean the metal suction screen.

4. Unit stops automatically

before 18 minutes.

A. GFCI/ELCB trips. A. Identify the source of the fault

and correct. Refer to the

installer/dealer.

Kohler Co. 17 1054216-2-B

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Comments to this Manuals

No comments

Kohler K-1166-C1-96 Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Space heaters Kohler K-1166-C1-96