Kohler K-1166-C1-96 Installation Guide download pdf (Page 2)

Important Information

WARNING: When using electrical products, basic precautions should always be followed,

including the following:

DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault

Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).

WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.

WARNING: Risk of electric shock. Disconnect power before servicing.

WARNING: Risk of injury or property damage. Please read all instructions thoroughly before

beginning installation, including the following requirements.

NOTICE: Follow all local plumbing and electrical codes.

Install to permit access for servicing.

A green with yellow stripe lead wire is provided within the wiring compartment. To reduce the risk of

electrical shock, connect this wire to the grounding terminal of your electric service or supply panel with

copper wire equivalent in size to the circuit conductor supplying this equipment.

A pressure wire connector is provided on the exterior of the pump or control within this unit to permit

connection of a bonding conductor between this unit and all other exposed metal in the vicinity, as needed to

comply with local requirements.

Grounding is required. The unit should be installed by a qualiﬁed service representative, and grounded.

Building materials and wiring should be routed away from the pump body and other heat-producing

components of the unit.

Important Product Information

Product Notices

WARNING: Unauthorized modiﬁcation may cause unsafe operation and poor performance of the

bath. Do not relocate the pump, or make other modiﬁcations to the circulating system, as this could

adversely affect the performance and safe operation of your bath. Kohler Co. shall not be liable

under its warranty or otherwise for personal injury or damage caused by any such unauthorized

modiﬁcation.

Product Inspection

Carefully unpack the product, and inspect the unit for damage. Return the unit to the carton during

construction to prevent damage.

Factory-Assembled Features

Factory installed components include pump, level sensors, in-line heater, submerged chromatherapy lights

(optional), control and switch. The pump and piping are factory-assembled.

Connections and Service Access

NOTICE: Provide unrestricted service access to the pump and heater. Provide unrestricted service access

to the pump, in-line heater, adjustable feet, and control box. You must construct an access panel to provide

sufficient clearance for servicing the pump, in-line heater, and control box. The access panel must be

located immediately next to the pump and in-line heater. Study the roughing-in information.

1054216-2-B 2 Kohler Co.

1 2 3 4 5 6 7 ... 63 64

No comments

Kohler K-1166-C1-96 Installation Guide Page 2