Kohler K-1166-C1-96 Installation Guide download pdf (Page 9)

5. Position the Unit

IMPORTANT! Risk of product damage. Do not lift or support the overﬂowing bath by the pump or

piping.

NOTE: Do not use adhesive or a cement or mortar bed to secure this product to the subﬂoor.

With help, carefully lift the overﬂowing bath into place. Using metal plates under the adjustable feet

is recommended and will make leveling the bath easier.

NOTE: If you do not have a 6’ (1.8 m) level, go to the next section.

Level by turning the adjustable feet up or down with the wrench (7/8″) attached to the harness near

the pump. Make sure all six adjustable feet rest directly on the subﬂoor, and make sure the bathing

well rim is level within 1/8″ (3 mm) in all directions.

Cut and discard the banding straps from the pump.

Make sure the rubber isolation feet are in place.

Insert the drain tailpiece into the trap.

Pump Banding

Straps

Adjust Feet

Check Level

Cut Straps

Wrench

Metal Plate

Adjustable

Foot

Kohler Co. 9 1054216-2-B

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

No comments

Kohler K-1166-C1-96 Installation Guide Page 9