Kohler K-5702-GW-0 Installation Guide download pdf (Page 12)

Operating the Air System

IMPORTANT! This product contains an automatic water purge mode that turns the blower on for 2

minutes approximately 30 minutes after the unit is turned off and drained.

NOTE: The water temperature in the bath should never exceed 104°F (40°C).

Close the drain, then ﬁll the bath at least 4” (102 mm) above the top of the highest airjet.

Use your hand to test the water temperature for comfort and safety, then carefully enter the bath.

Press the [On/Off] icon to turn the blower on at medium speed.

Press the [Up] or [Down] arrow icons to increase or decrease the air ﬂow.

NOTE: The blower will turn off automatically following 20 minutes of operation, and can be immediately

restarted if desired.

Press the [On/Off] icon a second time to turn off the blower.

Carefully exit and drain the bath.

Press the [Purge Mode] icon to blow remaining water from the air channels. The blower will turn

on for 2 minutes and then turn off automatically.

NOTE: About 30 minutes after the blower motor stops, a 2 minute purge mode will automatically start.

NOTE: If the bath does not function properly, refer to the ″Troubleshooting″ section.

Purge Mode

On/Off

Increases Flow

Decreases Flow

1237792-2-E 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

No comments

Kohler K-5702-GW-0 Installation Guide Page 12