Kohler K-5702-GW-0 Installation Guide download pdf (Page 13)

Operating the Heated Surface

Keypad Operation

Power Icon - Turns the heater on and off.

Heat/Temperature Indicator - The [Flame] icon illuminates yellow, orange, or red depending on the

heat level. Yellow indicates low heat, orange indicates medium heat, and red indicates high heat.

Up Arrow - Increases the temperature.

Down Arrow - Decreases the temperature.

NOTICE: The heater will remain on until it is manually turned off by pressing the [Power] icon.

NOTE: After 60 minutes of inactivity, the heater will automatically reset to low heat if the temperature

was set to medium or high.

NOTE: The heater will turn on at the last selected temperature setting.

Error Codes

Heat indicator blinking red - The heater is not functioning.

Heat indicator blinking yellow - The temperature sensor is not functioning or is loose.

Refer to the ″Troubleshooting″ section to troubleshoot any problems.

Conﬁrm Heating System Operation

Press the [Power] icon on the user keypad.

Observe that the heat indicator turns yellow and the heater produces low heat.

Press the [Up] arrow. Verify that the heat indicator turns orange and the temperature increases.

Press the [Up] arrow a second time. Verify that the heat indicator turns red and the temperature

increases.

Press the [Down] arrow. Verify that the heat indicator turns orange and the temperature decreases.

Press the [Down] arrow a second time. Verify that the heat indicator turns yellow and the

temperature decreases.

Press the [Power] icon to turn the heater off.

Increase Temperature

Decrease TemperaturePower On/Off

Heat/Temperature Indicator

Kohler Co. 13 1237792-2-E

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

No comments

Kohler K-5702-GW-0 Installation Guide Page 13