Kohler K-5702-GW-0 Installation Guide download pdf (Page 9)

5. Make the Electrical Connections – Canada

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

WARNING: Risk of electric shock. Connect the blower motor to a properly grounded,

grounding-type Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD). This

will provide additional protection against line-to-ground shock hazard.

Locate and secure each supplied junction box a minimum of 1-1/2″ (38 mm) above the subﬂoor.

The bath controls and system have been prewired at the factory. A qualiﬁed electrician should make

a routine service connection to the junction box.

Connect service to the junction box. The 60 Hz model junction box contains line (black) and neutral

(white) wires and a ground lug.

A 120 V, 15 A dedicated circuit is required. Provide a Class A GFCI or RCD.

Provide a separate equipment grounding conductor for the inside ground or ground lug. The

conductor must not be connected to any current-carrying conductor.

Bond in accordance with national and local codes.

NOTICE: For -G2MW Music Models: Refer to the installation instructions included with the ampliﬁer for

wiring and installation details. Position the ampliﬁer anywhere within the shroud or in a remote location.

If installed within the shroud, the ampliﬁer will need to remain plugged into the electrical outlet at all

times.

Blower Motor

Electrical Cord

Wire Connectors

Provide suitable

strain relief.

Wire the junction box as shown.

Line (Black)

Ground

From Blower

Neutral (White)

Supply from

Branch

Circuit Box

Ground

From Bask

Power Supply

Bask Power

Supply Cord

Junction

Box

Kohler Co. 9 1237792-2-E

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

No comments

Kohler K-5702-GW-0 Installation Guide Page 9