Kohler K-2971-KS-NA Installation Guide download pdf (Page 13)

9. Water Temperature Adjustment

CAUTION: Risk of personal injury. To eliminate the risk of

scalding, the water temperature should never be set above

120°F (49°C).

NOTE: Do not remove the O-ring and collar at this time. Removing

the O-ring and collar will change the factory setting for the

maximum water temperature.

Turn the valve clockwise to the full open position and let the hot

water run for several minutes. Position a thermometer in the

water stream and check the temperature.

For minor water temperature changes, adjust the setscrew, and

recheck the water temperature.

For major water temperature changes, remove the O-ring and

collar from the valve stem. Slowly rotate the valve stem until the

desired maximum water temperature is reached.

Reinstall the collar on the valve stem with the setscrew against

the side of the tab.

Reinstall the O-ring, rotate the valve stem counterclockwise to

shut the water off.

Recheck the water temperature.

Install the valve trim according to the instructions packed with

the product.

Complete the information on the valve label (if supplied).

Setscrew

O-Ring

Tab

Valve

Stem

Valve

Label

Collar

Kohler Co. 13 1150733-2-A

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Kohler K-2971-KS-NA Installation Guide Page 13