Kohler K-349-G Installation Guide download pdf (Page 4)

1. Install the Posts

Locate the Mounting Holes

IMPORTANT! The slide bar must be mounted to stud framing

supports at both the top and bottom mounting locations. Do not use

or depend on plastic wall anchors to attach the slide bar.

NOTE: The slide bar should not be installed in an area 24″ (61 cm)

to 48″ (121.9 cm) from the ﬂoor.

For K-8524: Mark the top mounting hole location then measure

down 28″ (71.1 cm) from the ﬁrst mark to determine the bottom

mounting hole location. Verify both marked locations are over a

stud.

For K-9069: Mark the top mounting hole location then measure

down 22-3/4″ (57.8 cm) from the ﬁrst mark to determine the

bottom mounting hole location. Verify both marked locations are

over a stud.

For tile or solid surface material: Drill a 3/16″ hole through the

ﬁnished surface only. Do not drill into the stud or the screws may

not hold.

Install the Escutcheons and Posts

Apply silicone sealant into the groove on the backside of an

escutcheon.

Position an escutcheon and post over the top mounting hole.

Post

Screw

K-8524: 28" (71.1 cm)

K-9069: 22-3/4" (57.8 cm)

Escutcheon

Mark the bottom mounting

minimum 48" (121.9 cm).

Mounting

Hole

1046145-2-C 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Kohler K-349-G Installation Guide Page 4