Kohler K-349-G Installation Guide download pdf (Page 6)

2. Install the Slide Bar

While holding the post, thread the pin into the post. Tighten with

a ﬂat blade screwdriver. Repeat for the other pin.

Line up the hole in the lock assembly with the hole in the slide

bar. If needed, use a small screwdriver to adjust the position of

the slide bar locks at each end of the slide bar assembly.

Align the pins with the holes in the slide bar and slide bar locks.

Gently press the slide bar against the posts, inserting the pins into

the slide bar locks. The slide bar should ﬁt snug against the posts.

Secure the slide bar by tightening the setscrews into the slide bar

locks until the setscrew is snug against the pins.

Press the caps into either end of the slide bar.

Post

Cap

Slide Bar

Lock Assembly

O-Ring

Handshower

Holder

Setscrew

1046145-2-C 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Kohler K-349-G Installation Guide Page 6