Measure the distance of the glass between
the wall jamb and the tray ‘A’. Cut the
splashguard to size cutting at the wall jamb end.
Fit the splashguard to the bottom of the glass
10
19
CFI230G
STEP
19
STEP
20
If the any further adjustment is required to make
the glass panel vertical turn the 4 screws ‘D’
until the panel is in the correct position
D
STEP
18
COMMISSIONING
1. General
1.1. Turn on the water supply to the Digital Mixer.
1.2. Check for leaks over the complete system.
1.3. Turn on the electrical supply to the Digital Mixer.
For the Pumped Version with the Slider Rail Shower System, pump priming can be helped by removing the
handset and lowering the end of the hose into the shower tray.
2. Set the Maximum Temperature
Note! The maximum temperature of the unit can only be set when the unit has not been used for a period of
10 minutes.
2.1. Temperature Selection - Set the temperature control knob to the desired position, as per the table
below.
2.2. Enabling - Press and momentarily hold the Warm Up and High keys at the same time. Release the
push-button and reselect within 2 seconds. The two keys will flash twice and beep three times to
confirm the selection is successful.
3. Lock Mode
Note! Allows you to lock the unit during operation.
3.1. Selection - Press and momentarily hold the Warm Up and Medium keys at the same time. The two
keys will flash twice and beep three times to confirm the selection is successful.
3.2. Operation - This mode locks out all the keys except the Warm Up/Off key. It also locks the temperature
control knob. Once selected it is only possible to turn the unit OFF.
Selecting Warm Up/Off and Medium at the same time again, cancels the lock mode.
Temperature Control Temperature Selection
o
C
Knob Position
1 Factory Set 45
2 39
3 40
4 42
5 43
6 44
7 45
7. 5 4 6
8 47
9 48
STEP
21
A
CFI230G
A
B
C
The edge of the glass should fit against the end
of the slot in the tray ‘B’. To adjust the glass
loosen the 4 screws ‘C’ and move the panel until
it is the correct postion. Re-tighten screws
Check the wall channel and jamb is vertical.
Loosen screws ‘A’ to adjust from side to side.
Re-tighten screws
Check end of
glass is vertical
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals