Kohler K-6546-3-47 Installation Guide download pdf (Page 10)

5. Undercounter/Solid Surface Preparation

CAUTION: Risk of personal injury or product damage. Cast

iron sinks are very heavy. Get help lifting the sink into place.

NOTE: Instructions in this section are for both undercounter and

solid surface installation. Any differences are noted in the text.

Verify that the sink will ﬁt in the cabinet opening. If necessary,

sand the opening or add wood ﬁller strips.

For solid surface installation, install the faucet to the sink

according to the manufacturer’s instructions.

Install the strainer or garbage disposal to the sink according to

the manufacturer’s instructions.

Apply a 1” (2.5cm) spot of sealant at each corner of the frame

where it will contact the sink.

NOTE: If using shims additional sealant will be needed.

Carefully position the sink within the frame, making sure to

center the sink in the cabinet.

Optional: Apply sealant between the cabinet and the apron.

Verify that the sink is level. The top of the sink should be ﬂush

with the top of the cabinet to allow proper countertop

installation. Adjust or shim between the sink and support if

needed.

Due to the various cut-out sizes possible, a template is not

supplied. If using the K-5984 cutting board, the minimum cut-out

length is 31″ (78.7cm).

"Y"

Wood Filler Strip (Optional)

Sink Rim Flush

With Top of

Cabinet

1019950-2-B 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Kohler K-6546-3-47 Installation Guide Page 10